Hydromassage System + Aeromassage

Since ancient times, water has been used for therapeutic purposes - water massage; water pressure which brings a lot of benefits to the human body.

The use of water for therapeutic purposes has determinated increasingly sophisticated methods of obtaining benefits for human health.

 

Hydrotherapy acts as a massage through jets of water with pressure on the muscles, relaxing it, improving and stimulating blood circulation, acting on the skin, opening and cleaning the pores; so the skin becomes smooth and shiny.

Using hydomassage make recovery faster after intense effort.

Our increasingly rhythm of life, daily stress, requires the use of relaxation, recreation and recovery methods. Now you can relax in the privacy of your home with the aeromassage system.

The aeromassage is produced by bubble air jets that stimulate skin receptors, reduce muscle tension and relax. Another beneficial effect is skin regeneration by pore dilation and make clean them.

Aeromassage is one of the most effective methods of recuperation and relaxation.

 

The Hydromassage + Aeromassage combination is the perfect match of water pressure and air bubble jets to produce amazing results.

The standard system is equipped with 6 hydromassage jets, which can be square or round, small or large, depending on the design of the bathtub and their location. The number of jets may be increased according to customer preferences as technically as possible.

The water is recirculated by a 700W pump. A 900W pump is used if the bathtub is equipped with more than 8 jets or the system is installed on bathtubs with a large volume of water.

To protect the pump, the system is equipped with a level sensor, which prevents the pump running without water. The level sensor is positioned on the bathtub so that the water overtakes the system's siphon. The systems doesn't work if this require is not done. During operation, if the water level in the tub falls below the level sensor, the control panel will shut down the system; the system will restart after the water level has been corrected.

The Hidro cycle is scheduled to run for 30 minutes and then automatically shuts off. For another cycle or to interrupt the cycle, use the control keys.

The aeromassage system consists of 12 aeromassage diuses, located on the length of the bathtub, a blower that pushes the air through the diuses to form bubble jets.

During operation, the intensity of the air jets can be increased or reduced in 5 steps by pressing the key on the control block.

The aeromassage cycle is set to 20 minutes, after that  the control panel will turn off the system. To restart, you must press the start key.

After emptying the water in the tub, at the end of the cycle, the green LED flashes for 20 minutes, which means that the automatic pipe cleaning cycle has been started.

After 20 minutes of waiting, the blower will automatically switch on for 1.5 minutes, after which the system is waiting for a new cycle.